Above is my process shown through pictures. I could not take any pictures of my project when it was being used because I cant use my phone if it is in the holder.
Recipe
Above in the slide show you can see my steps from beginning to end and my journey through this project. First I had to create a sketch in inventor. Then I used the extrude tool to make the phone holder 3D. Then I exported it and put it in Makerbot and changed the settings to make it print correct. Next I looked at the print preview to make sure it looked good. Finally I sent it to my flash drive and took it to the 3D printer.
Summary
In this project I got a better understanding of how to use inventor, makerbot and a 3D printer. In the widget project I did not fully learn how to use these tools but in this project I learned most of the software.